Arduino library for the MMA8451 Accelerometer sensors in the Adafruit shop Arduino library for the MMA8451 Accelerometer sensors in the Adafruit shop
Device OS Version:
This table is generated from an automated build. Success only indicates that the code compiled successfully.
This content is provided by the library maintainer and has not been validated or approved.
#Adafruit MMA8451 Accelerometer Driver #
This driver is for the Adafruit MMA8451 Accelerometer Breakout (http://www.adafruit.com/products/2019), and is based on Adafruit's Unified Sensor Library (Adafruit_Sensor).
The MMA8451 is a low-cost but high-precision digital accelerometer that uses repeated-start I2C mode, with adjustable data rata and 'range' (+/-2/4/8).
More information on the MMA8451 can be found in the datasheet: http://www.adafruit.com/datasheets/MMA8451Q-1.pdf
The Adafruit Unified Sensor Library (https://github.com/adafruit/Adafruit_Sensor) provides a common interface and data type for any supported sensor. It defines some basic information about the sensor (sensor limits, etc.), and returns standard SI units of a specific type and scale for each supported sensor type.
It provides a simple abstraction layer between your application and the actual sensor HW, allowing you to drop in any comparable sensor with only one or two lines of code to change in your project (essentially the constructor since the functions to read sensor data and get information about the sensor are defined in the base Adafruit_Sensor class).
This is imporant useful for two reasons:
1.) You can use the data right away because it's already converted to SI units that you understand and can compare, rather than meaningless values like 0..1023.
2.) Because SI units are standardised in the sensor library, you can also do quick sanity checks working with new sensors, or drop in any comparable sensor if you need better sensitivity or if a lower cost unit becomes available, etc.
Light sensors will always report units in lux, gyroscopes will always report units in rad/s, etc. ... freeing you up to focus on the data, rather than digging through the datasheet to understand what the sensor's raw numbers really mean.
Adafruit invests time and resources providing this open source code. Please support Adafruit and open-source hardware by purchasing products from Adafruit!
Written by Kevin (KTOWN) Townsend & Limor (LADYADA) Fried for Adafruit Industries.